News
Brief analysis of deep drawing deformation process
What is deep drawing
Deep drawing refers to a stamping process that uses a deep drawing die to press a blank of punched flat sheet into various open hollow parts, or to process the already-made open hollow parts into other shapes of hollow parts.
II. Structural Features of Deep Drawing Die
The structure of the drawing die is relatively simple. Compared with the blanking die, the working part is provided with larger fillets or slopes, with high surface quality requirements. The clearance between the male and female dies is slightly larger than the thickness of the sheet metal.
III. Deformation characteristics and process of drawing materials
The attached figure shows the process of straight cylinder stretching, where the planar material is transformed into a vertical side wall.(figure 1)


Figure 1 Figure 2
The main deformation zone of the planar drawing part: The planar material is drawn through the male and female dies, and changes from a planar surface to a lateral straight surface or a specific shaped surface.
Die fillet transition zone: The arc angle of the male and female dies controls the material flow speed and pressure, allowing the material to flow smoothly and avoiding problems such as cracking and wrinkling.
The force transfer area of the cylinder wall: This is the main functional area of the product, which can be thinned during stretching, depending on the material properties and the height of the stretch.
The transition zone of the circular corner of the punch: The transition zone of the pressing material can be made into a circular arc to avoid material breakage and reduce material flow resistance.
IV. Material stress trend during the drawing process
During the material drawing process, the material is drawn from the plane into the interior of the die. The top and bottom R-angles are both deformation flow zones, and the straight section of the cylinder wall is subjected to vertical tension, causing the material to be drawn thin.(figure 2)
V. Difficulties in deep drawing and solutions to wrinkling
Wrinkling and factors affecting wrinkling:
(1) The relative thickness of the flange part material, where the flange part material thickness exceeds one material thickness, resulting in stacking wrinkles. Solution: adjust the pressure force and the clearance between the male and female dies.
(2) During deep drawing, the gap is not effectively controlled by pressing the material, and the flowing material accumulates in the larger gap, resulting in wrinkling and tearing.
(3) The mechanical properties of the material are low, and repeated deep drawing forms internal deformation stresses that are not removed in time, causing the material to flow difficultly and wrinkle.
Solution for wrinkles:
(1) Reduce the gap between the inside and outside R angles of the flange part, with a thickness less than one material thickness, taking a value of 0.95-0.98T.
(2) During deep drawing, the blank holder plate should have sufficient strength, with methods such as ribbing and blank holder blocks to control clearance and blank holder force.
(3) When the mechanical properties of the material are weak and multiple deep drawing is required, annealing should be used to eliminate stress during the process.